1. The automatic baler does not automatically take the tape out. In this case, first check whether the “outgoing tape length adjustment” is at “0”, and then see if the tape is correctly processed. If it is not, send the foreign matter stuck near the roller. Cause this situation.
2. Does not move when inserting the tape: The LS1 micro-switch on the right side of the slide board is faulty or the elastic piece is blocked by the foreign matter, and it cannot touch the contact point. Continuous operation: a. LS5 faults b and LS1 are not broken, but there are stolen objects stuck between the contacts and the shrapnel, or the shrapnel itself is stuck so that the contacts cannot be released after the insertion. c. When LS5 returns to zero, there is no closed circuit in the contact, so that the power supply will continue to work when it is turned on.
3, poor adhesion: a, the temperature is too high or not enough, sometimes more special tape, poor viscosity, the temperature must be very accurate. b. The voltage is not enough. There are many factory voltages, which are often insufficient. If you use an extension cable or cable, the pressure drop will cause the original adjustment temperature to become lower, even when the motor is burned, so try to avoid using cables. If you must use an extension cord, you must use a thicker, not too long, cord. c. The 635 bearing under the knife is broken, so it is heated and completely unable to bond. d. The long pull springs on the electric hand (swing rod) are tired, so it is impossible to hold the strange hand to position, resulting in half or even less adhesion. e, electric steel sheet is too high or too low, or biased to the left, so hit the upper and lower PP belt, or left and right tools, and can not enter the heating, depending on the circumstances to adjust. f. The micro fan failure of the exhaust fumes causes the temperature to be too high.
4, cassette processing, when the tape stuck in the middle of the roller, or foreign matter can not be plugged out, the processing method is as follows: a, disassemble the hexagon nut washer. b. Loosen the two M5 countersunk screws on the center of the connecting shaft. Since these two screws are fixed on the notch portion of the connecting shaft, the screws must be turned on. c. Take off the connecting shaft, pick up the upper turbine and remove the jam. d, according to the above cba way assembly recovery. e. Note that the nut and L-curvature maintain a 0.3-0.5mm gap. 5. There is a lot of situations that will cause this situation after the tie is not cut: a. The tightness adjustment is too tight. b. The slide or the slippery belt has oil. All are located near the elastic adjustment. The oil must be removed and removed. c. The belt is too tight. Lower the belt drive seat downwards or adjust the motor backwards. d. Use thinner belts or retract rollers with too much clearance.
Our company also main to design Plastic Products, Paper Products, Wooden Products, Household Products, Stationery Products, Sewing Products and so on
Triple C International (ShenZhen) Co.,Ltd. was established in 2018. It`s a professional foreign trade company engaged in import and export trade, and carries out business operations such as international trade, cooperative production and intermediary trade. The company mainly provides high-quality OEM-product and ODM-product services for customs in Japan, Southeast Asia, Europe and Unite States, and has a professional technical team that provides hundreds of OEM-product services for dozens of customers, and has dozens of excellent suppliers. The company mainly provides sewing products, plastic products, paper products, wooden products, household products and other OEM services, including handbags, gift boxes, Storage Boxes, stationery boxes, kid toys, Paper Boxes, school supplies, office supplies and other products import and export business.
